Laser Cutter Progress

We now have the laser cutter fully hooked up and working. Below is a picture of the back of the laser cutter where you can see the exhaust hose, the compressor and the water chiller.


We have been testing the laser cutter by cutting some of the thin board that Ross brought in to use for the walls of the Halloween electric chair. This is shown below.


We still have a lot to do to determine the correct parameters to use for cutting or engraving the various materials we have available for use. We also have to continue the exploration of the laser’s software. Once this is done I will setup classes so that anyone who wishes to attend may get certified to use the laser cutter.